U3042AE08
System Setup with N5230C
WARNING
Preparing the N5230C Network Analyzer
1. Remove the feet from the bottom of the network analyzer. Refer to
2. Remove the 2 lower standoffs and screws (0515-1619) from the rear panel on the
network analyzer.
Figure 6
3. Install the two rear locking feet (5023-0132) onto the PNA-L, using the included screws
(0515-1619), where the standoffs were removed. Refer to
Figure 7
Screws (0515-1619)
Included in package
12
This Manual:http://www.manuallib.com/agilent/u3042ae08-test-set-user-guide.html
The opening of covers or removal of parts is likely to expose
dangerous voltages. Disconnect the instrument from all voltage
sources while it is being opened.
Rear Bottom Feet
Standoffs (x2)
Feet (x4)
Install Locking Feet
System Setup with N5230C
Figure
6.
Figure
7.
Locking Feet
(5023-0132)
User's Guide U3042-90002