Unpacking Erx-7Xx Models And Erx-310 Routers - Juniper E Series Hardware Manual

ERX 7.0.x Hardware Guide
WARNING: Three people are required to install the E-series router in a rack: two to
lift the system into position and one to screw it to the rack.
To unpack ERX-14xx models:
1.
2.
3.
4.
Figure 16: Removing an L-Bracket

Unpacking ERX-7xx Models and ERX-310 Routers

ERX-7xx models and ERX-310 routers are shipped boxed, but not attached to a
skid. For your convenience, Juniper Networks recommends that you unpack
the E-series router in the location where you want to install it.
24
Unpacking ERX-7xx Models and ERX-310 Routers
Cut the two straps that secure the carton to the skid, open the carton from the
top, and remove the box of accessories that sits on top of the router.
Unlock the four plastic clips that hold the box to the skid by squeezing them in
their center and pulling out, and then lift the carton off the router.
Remove the three screws that attach each of the two L-brackets to the router.
To avoid scratching the router when removing it from the skid, detach one of
the L-brackets from the skid by removing the three screws. See Figure 16.
L-bracket