Cabling E-Series Routers; Cabling Overview - Juniper E Series Hardware Manual

Chapter 5

Cabling E-series Routers

Cabling Overview

This chapter describes how to cable an E-series router. Before you cable the
router, ensure that you have completed all installation instructions identified in
previous chapters.
This chapter contains the following sections:
Cabling Overview on page 51
Required Tools, Wires, and Cables on page 53
Cabling the SRP I/O Module on page 54
Cabling the E-series Router for Power on page 58
Cabling I/O Modules on page 64
The Next Step on page 70
Cabling an E-series router requires the following main tasks:
Familiarize yourself with the module ports, and ensure that you have the cables
1.
and wires needed to complete each cabling procedure (see Figure 26).
Read and understand all safety warnings. (See "Installation Guidelines and
2.
Requirements" on page 125.)
(Optional) Connect timing ports.
3.
Connect the SRP I/O module to the network and to a management console.
4.
Connect grounding wires to the E-series chassis.
5.
Connect the power cables from the power source to the power input module.
6.
Connect the line I/O modules to their appropriate network interface.
7.
51
Cabling Overview