ERX 7.0.x Hardware Guide
Verifying the Installation
To verify that the installation is complete:
1.
2.
Configuring Line Module Redundancy
For information about configuring line module redundancy, refer to JUNOSe System
Basics Configuration Guide, Chapter 5, Managing Line Modules and SRP Modules.
The Next Step
After you install the modules, you can connect cables to the system. Turn
to "Cabling E-series Routers" on page 51.
50
The Next Step
After you have cabled the system for power (see "Cabling E-series Routers" on
page 51), turn on the power switches.
The system reboots.
Issue the show redundancy command, and verify that the display shows
the redundancy hardware.