Juniper E Series Hardware Manual page 59

4.
5.
Figure 23: Ejectors in the Open Position
6.
CAUTION: If you meet strong resistance when attempting to seat the module
using the ejectors, remove it from the chassis and confirm that the slot is one
designed to hold the module. Then check, if applicable, that the module matches its
corresponding module (I/O module or line module). Also, be sure that you have
aligned the top and bottom edges in the correct matching tracks.
Remove the SRP module from its antistatic bag.
Verify that the ejectors are in the open position, as shown in Figure 23.
Œ
Opened

Closed

Closed
Œ
Opened
Slide the module into the chassis by placing it between the guides of the
selected slot and pushing the module until it stops.
The module stops sliding when the ejectors make contact with the front
of the chassis.
Installing Modules
Installing SRP I/O and SRP Modules
43