Installing A Drive In Bay 2 Or 3 - IBM Aptiva Handbook

Installing a drive in bay 2 or 3

Bay 2 or 3 can hold up to a 5.25-inch half high drive, such as a diskette, hard disk, tape, or CD-ROM drive.
1.
Insert the drive into the bay. Align the screw holes
and insert the four screws.
(Front View)
2.
Connect the power and signal cables to the drive.
Drive
Power Cable
Signal Cable
Audio Cable
Drive
If you add a diskette drive or tape drive that attaches to the
Diskette connector, make sure the signal cable you plug into
the drive is attached to the Diskette connector on the
note: system board. If you add a CD-ROM, it is recommended that
you use the signal cable attached to Local Bus connector
on 2 on the system board. To identify the connectors, see
"Identifying signal cable connectors" on page 110.
Working with the hardware in the minitower system unit
(Back View)
115