For Drives - IBM Aptiva Handbook

For drives

When you install a diskette drive, you should check the
size and storage capacity of the drive in the Setup Utility.
To specify the diskette drive size and capacity, select the
Disk Drives option on the Setup Utility Main Menu. See
"Changing disk drive configuration" on page 33 for
information about this option.
If you remove a diskette, hard disk, or CD-ROM drive,
the power-on self test generates an error message. In
the Setup Utility, verify that the information the BIOS
automatically recorded is correct. Use this opportunity
to verify that the remaining drives are installed as
intended.
Select the following options from the Setup Utility's
Main Menu to verify drive setup:
•
System Information
See "Viewing system information" on page 33 for
information about this option.
•
Disk Drives
See "Changing disk drive configuration" on page 33
for information about this option.
•
Startup Options
See "Configuring startup options" on page 43 for
information about this option.
120 Chapter 7: Adding and removing adapter cards and drives