IBM Aptiva Handbook page 112

Installing a drive in bay 4 (continued)
3.
Right bracket replacement
Slide the right bracket into the bay, making sure to
insert the catch into its slot. Also make sure the
riser card is located to the left of the bracket.
Align the screw holes. Insert the two front screws
first, then insert the remaining screws. (The riser
card should be located to the left of the bracket so
that the screws go through the riser card first.)
Right Bracket
Catch
1
2
(Front View)
98 Chapter 7: Adding and removing adapter cards and drives
4.
Hard disk cable connections
Connect all drive cables. Reinstall any drives you
removed in bays 1 and 2. For instructions on
installing a drive in bay 1, see page 91. For
instructions on installing a drive in bay 2, see
page 93.
Riser Card
Signal Cable
Drive
(Back View)
Power Cable