IBM Aptiva Handbook page 159

Table 7: Error codes, descriptions, and corrective actions (Continued)
Error Code Description
662 Diskette Drive Configuration
Error
762 Math Coprocessor
Configuration Error
962 Parallel Port Configuration
Error
1162 Serial Port Configuration
Error
1762 Hard Disk Configuration Error
Notes:
1. An X shown as part of the error code in this table represents any number between 0 and 9.
2. If any of these errors continue after taking the actions listed, check your online Aptiva Helper or the Guide to HelpWare and All
the Extras folder for information on obtaining service.
Here's what to do:
1. If you added or removed a diskette drive, press Enter while the error
message is displayed to enter the Setup Utility. Choose Input/Output Ports
from the Setup Utility Main Menu and verify that the Diskette Drive settings
are correct. If the settings are not correct, change the settings. For
instructions on using the Setup Utility, see "Using the Setup Utility" on
page 29.
2. If you did not add or remove a diskette drive, make sure the diskette drive
cables are connected correctly.
Check your Guide to HelpWare and All the Extras folder for information on
obtaining service.
If you installed or removed hardware, press Enter while the error message is
displayed to enter the Setup Utility. Choose Input/Output Ports from the Setup
Utility Main Menu and verify that the Parallel Port setting is correct. If the
setting is not correct, change the setting. For instructions on using the Setup
Utility, see "Using the Setup Utility" on page 29.
If you installed or removed hardware, press Enter while the error message is
displayed to enter the Setup Utility. Choose Input/Output Ports from the Setup
Utility Main Menu and verify that the Serial Port settings are correct. If the
settings are not correct, change the settings. For instructions on using the
Setup Utility, see "Using the Setup Utility" on page 29.
1. Make sure the cables to all drives are securely attached.
2. Press Enter while the error message is displayed to enter the Setup Utility.
Choose Disk Drives from the Setup Utility Main Menu. Make sure the settings
for the drive options are correct. If the settings are not correct, change the
settings. For instructions on using the Setup Utility, see "Using the Setup
Utility" on page 29.
Responding to error codes 145