Installing A Drive In Bay 1 - IBM Aptiva Handbook

Installing a drive in bay 1

Bay 1 can hold a 3.5-inch slim drive, such as a diskette or tape drive.
1.
Insert the drive into the bay. Align the screw holes
and insert the four screws.
(Front View)
114 Chapter 7: Adding and removing adapter cards and drives
2.
Connect the power and signal cables to the drive.
Drive
Signal Cable
Power Cable
Drive
If you add a diskette drive or a tape drive that attaches to
the Diskette connector, make sure the signal cable you
plug into the drive is attached to the Diskette connector on
note:
the system board. To identify the Diskette connector on the
system board, see "Identifying signal cable connectors" on
page 110.
(Back View)