Removing Memory Modules - IBM Aptiva Handbook

3.
Press forward firmly on the memory module to
move it into a vertical position. Both sides of the
module will "click" when the module locks into
place. The newly-installed memory module will be
locked into the socket in a vertical position with
pins showing through the holes on each side.
memory module (SIMM)
socket
70 Chapter 6: Adding and replacing system board components

Removing memory modules

To remove a memory module from its socket:
1.
Locate the two clips that hold the memory module
in place. One clip holds the left edge of the module
and the other clip holds the right edge.
hole
2.
At the same time, push both clips outward, away
pin
from the module. The module will release and
move forward.
3.
Lift the module out of the socket
memory module (SIMM)
socket
72-pin memory
module (SIMM)
memory module
socket
clip
.