IBM Aptiva Handbook page 91

Table 2: Adapter card configurations
If the adapter card or
and the adapter card
cards currently
you are installing is:
installed are:
None Plug and Play
Non–Plug and Play
Plug and Play Plug and Play
Non–Plug and Play
Non–Plug and Play Plug and Play
Non–Plug and Play
Both Plug and Play and Plug and Play
Non–Plug and Play
Non–Plug and Play
Note: ISA Plug and Play adapter cards should be clearly labelled as Plug and Play cards. PCI adapter cards should be considered
Plug and Play cards.
then:
Do not change any settings.
Do not change any settings.
Do not change any settings.
Change the settings in the Setup Utility's Plug and Play menu before you install
the new card. For instructions on working with these settings, see "Changing
adapter card device information" on page 42.
Change the settings in the Setup Utility's Plug and Play menu before you install
the new card. For instructions on working with these settings, see "Changing
adapter card device information" on page 42.
Do not change any settings.
Do not change any settings.
Change the settings in the Setup Utility's Plug and Play menu before you install
the new card. For instructions on working with these settings, see "Changing
adapter card device information" on page 42.
Resolving Plug and Play resource conflicts 77