Removing Adapter Cards; Adding And Removing Drives; Identifying Drive Bays - IBM Aptiva Handbook

access to a section of the system board, reconnect the
cables.

Removing adapter cards

If you need to remove an adapter card, follow the
instructions in step 1 on page 107 to position the system
unit. Remove the adapter card screw. Carefully pull the
adapter card straight out of the slot so that the card's
components do not bend. If an adapter card has cables,
disconnect them. Be sure to notice where the cables
connect to the cards. You will have to reconnect these
cables if you reinstall the card.
Adapter
Card
(Bottom)
(Front)
108 Chapter 7: Adding and removing adapter cards and drives
1
2
(Back)
(Top)

Adding and removing drives

The minitower system unit has six bays for various
types of drives. Some of these bays already hold drives
that were installed at the factory.
When you purchase a new drive, make sure you also
purchase the appropriate power and signal cables.

Identifying drive bays

The minitower system can accommodate 3.5-inch slim
and 3.5-inch half high drives, such as diskette and tape
drives. The system can also accommodate 5.25-inch half
high drives, such as diskette, hard disk, tape, and CD-
ROM drives. Four of the bays in your system have
external access. Two do not.
You can install a drive in any empty bay that
accommodates the drive's size. Use the following table
to help you determine where to install your drive.
Bay Drive Specifications
1 Can hold a 3.5-inch slim drive,
such as a diskette or tape drive.
2 Can hold up to a 5.25-inch half
high drive, such as a diskette, hard
disk, tape, or CD-ROM drive.
Note: Using the appropriate installation hardware, you can install
smaller drives than those listed here.
Bay Capacity
101.6 x 25.4
mm
(4.0 x 1.0 in.)
149 x 41.3 mm
(5.87 x 1.625
in.)