System Memory Test; Virus Detection; Viewing Model Information - IBM Aptiva Handbook

For example, if you select diskette drive A as the First
Startup Device, and Hard Disk 1 as the Second Startup
Device, your computer will search for the operating
system files on diskette drive A first and hard disk 1
second.
Hard disk 1 is the hard disk that came preinstalled in
note: your computer. For more information, see "Changing
disk drive configuration" on page 33.
Note that if you select a hard disk drive as your first
startup device and your system becomes corrupted, you
might not be able to recover lost or corrupted files using
the Product Recovery CD-ROM. See "Recovering factory
installed programs and files" on page 148 for recovery
instructions.

System memory test

This option lets you enable or disable the system
memory test, which is part of the power-on self test
(POST). The POST is a series of tests that check
components of your computer for proper operation each
time you turn your computer on. Disabling the system
memory test saves time when you turn on your
computer. Your operating system and programs become
available sooner.
44 Chapter 4: Viewing and changing Aptiva configuration

Virus detection

This option lets you specify whether you want the virus
checker that comes with your computer's BIOS to check
for viruses each time you turn on your computer.
When this virus detection is enabled, your computer
checks the master boot record to see if the information
there has changed since the last time you turned on the
computer. If the information has changed, the BIOS
displays a message that warns that your computer may
have a virus.
This option does not have an effect on the IBM
AntiVirus program or on additional virus checking
note:
programs you may have purchased. It also does not
remove viruses from your computer.

Viewing model information

From the Setup Utility Main Menu, select the Model
Information option to view information about your
computer model. You cannot change any information in
this menu. The Setup Utility automatically updates this
screen only if the Basic Input/Output System (BIOS) is
upgraded.
The Model Information menu contains the following
information:
•
Model Number
•
Serial Number
•
BIOS Version
•
BIOS Date