Tis Power-Up Test - Garmin G1000 Pilot's Manual

HAZARD AVOIDANCE

TIS POWER-UP TEST

The TIS system performs an automatic test during power-up. If the system passes the power-up test, the
standby screen is displayed on the Traffic Map Page. If the aircraft is airborne during the test, traffic is displayed
on the Traffic Page.
If the system fails the power up test, one of the following messages displays:
• NO DATA - Indicates that data is not being received from the transponder.
• DATA FAILED - Indicates that data is being received from the transponder, but a failure was detected in the
data stream.
• FAILED - Indicates that the transponder has failed.
Contact the service center or Garmin dealer for corrective action for these messages.
To change the map range, turn the Joystick clockwise to zoom out or counter-clockwise to zoom in. Map
ranges are 2 nm, 6 nm, and 12 nm.
TIS Not
Operating
TNA Mute
On/Off
Status
6-58
Figure 6-59 Traffic Map Page Power-up Test
Garmin G1000 Pilot's Guide for Cessna Nav III
No Data Being Received
from Transponder
TNA Mute Softkey -
Disables TIS Not Available
Nuisance Alerts
190-00498-01 Rev. A