Ground Lesson 3; Power-Up, Self-Test, Checklist; Exercise 3.1: System Initialization - Garmin G1000 Manual

Integrated flight deck pilot’s training guide
Hide thumbs Also See for G1000:
Table of Contents

Advertisement

Objectives
Upon completion of this lesson, the pilot should be able to correctly identify proper alignment
of the AHRS/ADC, complete a system self-test, and verify the database data.
Resources
• GIFD Pilot's Guide
• GIFD PC-based Simulator

Exercise 3.1: System Initialization

1. How does one verify the aircraft software upon power-up?
The aircraft system version information is located on the top right corner of the MFD
power-up splash screen and also on the AUX – System Status Page. It is very important to
make sure the correct aircraft software is loaded, especially after the aircraft has
undergone any maintenance action.
2. Is the aircraft required to remain stationary while the AHRS and ADC align?
No, the AHRS/ADC can align while the aircraft is moving and even in flight at bank
angles of up to 20°.
3. Is any warm-up time required for the engine instrumentation to be accurate?
No, a warm-up period is not required for engine instrument display accuracy.
4. What pilot action should be taken if the MFD system self-test does not pass?
The pilot should shut down the aircraft and contact maintenance.
5. Where can one verify the effective dates of the Jeppesen database during the initial system
start-up?
The Jeppesen database effective dates are located at the right-hand side of the MFD start
up splash screen at the conclusion of the scrolled text sequence.
6. If the Jeppesen database is not current in the GIFD, can the system still be used for IFR
flight?
Yes, but one cannot file a "/G" flight plan for GPS use or use the GPS for instrument
approach procedures.
7. How does one verify if the autopilot has passed its preflight system test?
Upon completion of the preflight test, the AFCS Status Annunciation 'PFT' will
extinguish and aural tone will be generated.
8. How does one verify if TAWS passed its preflight system test?
Upon completion of the preflight test, the 'TAWS TEST' annunciation will extinguish
and the voice alert, "TWAS system test OK", will be generated.
190-00368-05 Rev. B

Ground Lesson 3

POWER-UP, SELF-TEST, CHECKLIST

GIFD Pilot's Training Guide
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents