Garmin G1000 Pilot's Manual page 424

APPENDIX A
GDL 69A MESSAGE ADVISORIES
Message
GDL69 CONFIG – GDL 69
configuration error. Config service
req'd.
GDL69 FAIL – GDL 69 has failed.
MANIFEST – GDL software mismatch.
Communication halted.
GDC 74A MESSAGE ADVISORIES
Message
ADC1 ALT EC – ADC1 altitude error
correction is unavailable.
ADC1 AS EC – ADC1 airspeed error
correction is unavailable.
MANIFEST – GDC1 software
mismatch. Communication halted.
MISCELLANEOUS MESSAGE ADVISORIES
Message
FPL WPT LOCK – Flight plan waypoint
is locked.
FPL WPT MOVE – Flight plan
waypoint moved.
TIMER EXPIRD – Timer has expired.
DB CHANGE – Database changed.
Verify user modified procedures.
FPL TRUNC – Flight plan has been
truncated.
LOCKED FPL – Cannot navigate
locked flight plan.
A-14
Comments
GDL 69 configuration settings do not match those of backup configuration memory.
The G1000 system should be serviced.
A failure has been detected in the GDL 69. The receiver is unavailable. The G1000
system should be serviced
The GDL 69 has incorrect software installed. The G1000 system should be serviced.
Comments
GDC1 or GDC2 is reporting that the altitude error correction is unavailable.
GDC1 or GDC2 is reporting that the airspeed error correction is unavailable.
The GDC 74A has incorrect software installed. The G1000 system should be serviced.
Comments
Upon power-up, the G1000 system detects that a stored flight plan waypoint is
locked. This occurs when an aviation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this message.
This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
OR
update the waypoint name/identifier to reflect the new information.
The system has detected that a waypoint coordinate has changed due to a new
aviation database update. Verify that stored flight plans contain correct waypoint
locations.
The system notifies the pilot that the timer has expired.
This occurs when a stored flight plan contains procedures that have been manually
edited. This alert is issued only after an aviation database update. Verify that the
user-modified procedures in stored flight plans are correct and up to date.
This occurs when a newly installed aviation database eliminates an obsolete approach
or arrival used by a stored flight plan. The obsolete procedure is removed from the
flight plan. Update flight plan with current arrival or approach.
This occurs when the pilot attempts to activate a stored flight plan that contains
locked waypoint. Remove locked waypoint from flight plan. Update flight plan with
current waypoint.
Garmin G1000 Pilot's Guide for Cessna Nav III
190-00498-01 Rev. A