Garmin G1000 Pilot's Manual page 176

GPS NAVIGATION
11) Turn the small FMS Knob to enter the desired target altitude offset from the selected Direct-to.
12) Press the ENT Key to highlight 'Activate?' or turn the large FMS Knob to highlight the 'COURSE' field.
13) Turn the small FMS Knob to enter the desired course to the waypoint.
14) Press the ENT Key to highlight 'ACTIVATE?'.
15) Press the ENT Key again to activate the Direct-to.
Selecting a direct-to by city or facility name:
1) Press the Direct-to Key.
2) Highlight the city field (to the right of the identifier) or facility field (directly below the identifier) field.
3) Enter the city (to the right of the identifier field) or the facility (directly below the identifier field).
4) Once the desired city or facility name is displayed, press the ENT Key to confirm the selection.
5) Press the ENT Key to activate the direct-to.
Selecting a direct-to from a list of waypoints in an active flight plan:
1) Press the Direct-to Key.
2) Highlight the FPL field.
3) Turn the small FMS Knob to display a selection window showing all waypoints in the active flight plan.
4) Scroll through the list and highlight the desired waypoint.
5) Press the ENT Key twice to activate the direct-to.
Selecting a direct-to from the nearest airports list:
1) Press the Direct-to Key.
2) Highlight the NRST field.
3) Turn the small FMS Knob to display a selection window showing the 25 nearest airports.
4) Scroll through the list and highlight the desired airport.
5) Press the ENT Key twice to activate the direct-to.
Selecting a specific course to a waypoint:
1) Press the Direct-to Key.
2) Enter the desired destination waypoint
3) Press the ENT Key.
4) Highlight the 'CRS' field.
5) Enter the desired course.
6) Press the ENT Key twice to activate the direct-to using the selected course to the destination.
5-40 Garmin G1000 Pilot's Guide for the Cessna Nav III 190-00498-01 Rev. A