Table of Contents
Advertisement
Connector View
Label
Description
POWER
Power cable port
12 PIN XDCR 12-pin transducer
NMEA 2000
NMEA 2000
Garmin Marine Network cable port for connection to compatible Panoptix
ECHOMAP devices
NETWORK
NOTE: This device is not compatible with some Garmin Marine Network devices such as
GPSMAP
Ground screw
To prevent corrosion of the metal contacts, cover unused connectors with weather caps.
For best performance and to prevent corrosion, insert the cable connector fully into the port and turn the locking
ring clockwise to tighten it. If the split-collar locking ring is not installed, you must install it.
Connecting to Power
When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or
product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product
specifications. Connecting the power cable without the appropriate fuse in place voids the product warranty.
You should connect the red wire to the power source through the ignition or another manual switch to turn the
device on and off.
The brown and blue wires on the power cable are not used by this device and should not be connected. You can
cut and tape the ends of these wires for a clean install, if preferred.
1 Route the power cable between the power source and the device.
2 Connect the red power wire to the ignition or another manual switch, and connect the switch to the positive
(+) battery terminal, if necessary.
3 Connect the black wire to the negative (-) battery terminal or to ground.
4 Connect the power cable to the device, and turn the locking ring clockwise to tighten it.
4
network
®
, GSD
, and radar devices.
®
™
NOTICE
WARNING
, GCV
, and
™
™
Advertisement
Table of Contents
