•
Scope Trigger allows you to choose the method you want to use to trigger
the oscilloscope for a particular application. The three trigger modes are
Edge, Pattern, and Immediate.
•
Scope Markers has two sets of markers that allow you to make time and
voltage measurements. These measurements can be made either manually
(voltage and time markers) or automatically (time markers only).
•
Scope Auto Measure provides nine automatic measurements to fit the
acquired waveform to the display. These measurements are Period,
Risetime, Falltime, Frequency, +Width, −Width, Vp_p, Preshoot, and
Overshoot.
•
Scope Calibration allows you to calibrate the oscilloscope or the
oscilloscope/probe system.
See Also
Chapter 12, "Operator's Service," for details on calibrating the oscilloscope.
Using the Logic Analyzer
To access the Scope menus
3–9