To Load A Configuration - HP 1660CS-Series User Manual

To load a configuration

You can quickly load a previously saved configuration, saving the trouble of
manually setting up the measurement parameters.
Go to the System Hard Disk or System Flexible Disk menu.
1
Your choice here depends on where you saved the configuration.
Select the field below System and select Load from the pop-up menu.
2
Select the destination from the module list.
3
"System" loads only settings available under the System menus. "Analyzer"
loads data and settings for the analyzer. Scope loads data and settings for the
oscilloscope. "All" loads the system, oscilloscope, and analyzer configurations.
You can only load configuration files to the area from which the configuration
was taken. For instance, you cannot load an analyzer configuration file to the
system. Thus, if you select System, then select a file that contains only an
analyzer configuration, the configuration will fail. The file type field tells you
what type of information is in a file. Analyzer configuration files show
"166xan_config", oscilloscope configuration files show "166Xsc_config", and
system configuration files show "16[6/7]x_cnfg" in the file type field.
Specify a file name from which to load the configuration using the
4
from file field or scrolling with the knob.
Select Execute.
5
Loading system configuration for programmatic control
6-6
File Management
To load a configuration