Reset Button - Siemens SIMOTION D410 Commissioning Manual

Commissioning (hardware)

3.4 RESET button

3. All DRIVE-CLiQ connections (with SINAMICS S120 Power Module PM340, for example)
4. Startup of SIMOTION D410 is completed as soon as its RDY LED is lit in green color and
3.4 RESET button
Arrangement
The RESET button is located behind the blanking plate on the SIMOTION D410.
Performing a reset operation
A reset causes the entire system to be reset and requires the system to be ramped-up again.
It is similar to a "Power On Reset" except that the 24 V power supply does not have to be
switched off.
40
are identified automatically.
the RUN/STOP LED is lit in yellow or green color. The SIMOTION D410 is ready for
configuring after successful completion of the startup.
Note
The components' firmware is automatically updated, depending on the firmware version
on the SINAMICS components and on the CF card. During an FW update, please take
note of the messages and alarms in the SIMOTION SCOUT detail window. An FW update
on the SIMOTION D410 is signaled by the RDY LED flashing yellow, while on the DRIVE-
CLiQ components (TM, SMC, etc.) it is signaled by the RDY LED flashing red/green.
● FW update running: RDY LED flashes slowly (0.5 Hz)
● FW update complete: RDY LED flashes quickly (2 Hz)
Go offline once all the FW updates are complete, then switch the 24 V supply for the
upgraded initialization components off/on.
SIMOTION D410
Commissioning Manual, 04/2014