Siemens SIMOTION D410 Commissioning Manual page 189

Upgrading with a CF card
1. Switch off the SIMOTION D410 to be updated.
2. Insert the CF card into the SIMOTION D410.
3. Switch the D410 back on. The D410 starts to process the upgrade data. The SF/BF LED
4. Monitor the green flashing of the SF/BF LED.
Downgrading
If the upgrade has not been successful (for example, the machine is not behaving as desired),
the upgrade can be undone as follows:
1. Switch off the SIMOTION D410.
2. Set the service selector switch (switch 6) to ON.
3. Downgrading is indicated by a green flashing SF/BF LED (0.5 Hz).
4. Monitor the flashing of the SF/BF LED.
SIMOTION D410
Commissioning Manual, 04/2014
flashes green (0.5 Hz) during the upgrade.
– As soon as the upgrade has been completed successfully, the SF/BF LED goes out.
The device then starts up automatically in the upgraded configuration
(SF/BF LED display then depends on the operating mode of the device).
– If the upgrade was not successful, the SF/BF LED flickers red (10 Hz).
Figure 6-11 Switch position for downgrading
Reset the service selector switch (switch 6) to OFF immediately after the flashing code is
displayed.
– As soon as the downgrade has been completed successfully, the SF/BF LED goes out.
The device then starts up automatically in the restored configuration
(SF/BF LED display then depends on the operating mode of the device).
– If the downgrade was not successful, the SF/BF LED flickers red (10 Hz).
Note
If the service selector switch (switch 6) is not reset or not reset in good time to OFF,
this results in fault state "Service selector switch is still set to restore" (SF/BF LED
flickers red at 10 Hz).
In this case, switch the D410 off, reset the service selector switch to OFF and switch
the D410 on again. If the restoration was otherwise successful, the D410 starts up with
the restored configuration.
Maintenance and service
6.4 Performing a firmware and project update
189