Siemens SIMOTION D410 Commissioning Manual page 114

Commissioning (software)
5.6 Creating and testing an axis
The following setting options are available for the drive assignment:
● Assign drive
● Define assignment later
114
Figure 5-21 Assigning a drive
Assigning a previously configured drive
The axis is to be assigned to a drive at a later point in time.
This enables
– The PLC and motion control functions to be completely configured by a programmer
even without drive know-how using technology objects (e.g. TO axis) and loaded to the
device.
– The drives to be separately configured and optimized by a drive expert.
– The technology objects to be symbolically assigned later to the drive objects via an
interconnection dialog box.
SIMOTION D410
Commissioning Manual, 04/2014