Siemens SIMOTION D410 Commissioning Manual page 95

Procedure
1. Open the "Automatic Configuration" dialog box by selecting the "SINAMICS_Integrated >
2. Click the "Configure" button.
3. If the drive unit is not in the "Initial commissioning" state, the factory settings are restored
4. The drive object types can now be selected via a further dialog box.
5. Select whether a servo- or vector-type drive object is to be used.
SIMOTION D410
Commissioning Manual, 04/2014
Automatic configuration" command in the Project Navigator.
Figure 5-11 Starting automatic configuration
after acknowledging a prompt.
Figure 5-12 Selecting the drive object type
Commissioning (software)
5.3 Performing an online configuration
95