Siemens Sinumerik 828D Manual page 163

Handwheel X60 / X62
Via X60, you can connect one handwheel either with TTL or difference signals. Alternatively,
you can connect the handwheel via X62. You can connect only one handwheel to the module
because the signals from X60 are fed parallel to X62.
Use switch S2 to switch between TTL and difference signals.
Note
The handwheel is supplied by the MCP module with 5 V / 100 mA. An external power supply
is not permitted.
NOTICE
Handwheel connections
The SINUMERIK 828D software can process up to three handwheels. You can connect two
handwheels to the PPU. You can connect an additional handwheel to the machine control
panel.
Connector designation:
Connector type:
Table 7-48
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Connector designation:
Connector type:
Special feature:
Max. cable length:
PPU and components
Manual, 05/2015, 6FC5397-2DP40-3BA4
X60
15-pin Sub-D socket
Assignment of connector X60
Signal name
P5V
M
HW1_A
HW1_XA
N.C.
HW1_B
HW1_XB
N.C.
P5V
N.C.
M
N.C.
N.C.
N.C.
N.C.
X62
12-pin plug connector
No galvanic isolation
5 m
Type Meaning
V 5 V power supply
V Ground
I Handwheel pulses track A
I Handwheel pulses track A (negated)
- Not assigned
I Handwheel pulses track B
I Handwheel pulses track B (negated)
- Not assigned
V 5 V power supply
- Handwheel 2 pulses track A (negated)
V Ground
- Not assigned
- Not assigned
- Not assigned
- Not assigned
Anschließbare Komponenten
7.5 MCP Interface PN
163