Siemens Sinumerik 828D Manual page 109

The machine control panel is mounted from the front in a rectangular cut-out and attached
using tension jacks (0.5 Nm tightening torque). The tension jacks are included in the scope of
delivery. Tension jacks are also available as a spare part, see Section Spare parts and
accessories (Page 118).
Figure 7-7
Dimension drawing
Danger to life from hazardous voltage
It is possible to reach into installation holes for control devices (shown in gray in the drawing).
Make sure that no live parts can be touched behind the holes within a clearance of at least
85 mm (hatched area in the drawing).
PPU and components
Manual, 05/2015, 6FC5397-2DP40-3BA4
Mounting panel cutout
WARNING
Anschließbare Komponenten
7.2 MCP 310 USB
109