Siemens Sinumerik 828D Manual page 147

Do not connect any relays, valves or other inductive loads.
Connector designation: X53, X54
Connector type: 4-pin plug connector
Table 7-25
Pin
1
2
3
4
Table 7-26
Pin
1
2
3
4
X60 handwheel
Via X60, you can connect one handwheel either with TTL or difference signals.
Note
The handwheel is supplied by the MCP module with 5 V / 100 mA. An external power supply
is not permitted.
NOTICE
Handwheel connections
The SINUMERIK 828D software can process up to three handwheels. You can connect two
handwheels to the PPU. You can connect an additional handwheel to the machine control
panel.
Connector designation:
Connector type:
PPU and components
Manual, 05/2015, 6FC5397-2DP40-3BA4
CAUTION
Assignment of connector X53
Signal name Signal type
KT-OUT1
KT- OUT2 O
KT- OUT3
M V
Assignment of connector X54
Signal name Signal type
KT-OUT4
O
KT- OUT5
KT- OUT6
M V
Meaning
Output 1 lamp
Output 2 lamp
Output 3 lamp
Ground
Meaning
Output 4 lamp
Output 5 lamp
Output 6 lamp
Ground
X60
15-pin Sub-D socket
Anschließbare Komponenten
7.4 MCP 310C PN
147