Avaya Vantage K175 Installing And Administering page 36

Initial setup and connectivity
™
If Avaya Vantage
then the following occurs if one of the power sources is disconnected:
• If the power adapter is disconnected, Avaya Vantage
supports either the 802.3at or 802.3af specification, Avaya Vantage
the reboot.
• If the networking switch is disconnected, Avaya Vantage
™
If Avaya Vantage
connected, Avaya Vantage
Connecting Avaya Vantage
About this task
You can connect Avaya Vantage
Procedure
1. (Optional) Connect a power adapter to the 48-V DC power connector at the back of Avaya
™
Vantage
• Your network does not support the 802.3at (PoE) or 802.3af (PoE) injector specification.
• You want to use a Wi-Fi connection.
2. To use a wired Ethernet connection:
a. Plug one end of an Ethernet cable into the LAN connector at the back of Avaya
Vantage
b. Plug the other end of the Ethernet cable into an available LAN port in your network.
3. To use a Wi-Fi connection:
a. Tap Settings.
b. Tap Network > Network mode.
c. Select Wi-Fi.
d. On the Network screen, tap Wi-Fi and choose the required network.
e. (Optional) If prompted, enter the network credentials.
If you are using a wireless connection, you must connect Avaya Vantage
source.
Result
™
Avaya Vantage starts to initialize.
After the device receives the configuration file server address from DHCP, the device starts
downloading the required files from the file server. The startup process can take between 4 to 20
minutes depending on the files to be downloaded.
September 2018
is connected to both a 48 Vdc power supply and a PoE networking switch port,
is connected to the PoE networking switch and the power adapter is
™
continues to work without a reboot.
™
to your network by using a wireless or an Ethernet connection.
and plug the power adapter into an electrical outlet if:
™
.
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
™
reboots. If the networking switch
™
continues to work without a reboot.
™
to the network
™
continues to work after
™
to a power
™
36