Avaya Vantage K175 Installing And Administering page 134

Supported configuration parameters
Parameter
L2QVLAN
VLANTEST
PHY2TAGS
September 2018
Type Default Is set to
value default
on reset
Numeric 0 Yes
Numeric 60 Yes
Numeric 0
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
Description
• The Settings > Network > Ethernet > VLAN >
VLAN tagging (802.1Q) menu on the device. The
precedence is 5.
Specifies the 802.1Q VLAN identifier.
The range is from 0 to 4094.
This parameter is initialized from L2QVLAN_INIT
after turning the device on. The parameter is not
initialized from L2QVLAN_INIT after reset.
This parameter is supported in all modes.
For provisioning, use:
• A name=value pair in a DHCPACK message.
The precedence is 1.
• DHCP option 43. The precedence is 1.
• The SET command in the 46xxsettings.txt
file. The precedence is 3.
• LLDP. The precedence is 4.
- The parameter is set indirectly by receiving a
VLAN name with the "voice" prefix in the IEEE
802.1 VLAN Name TLV.
- The TIA LLDP MED Network policy TLV.
The Settings > Network > Ethernet > VLAN >
VLAN menu on the device. The precedence is 5.
Specifies the number of seconds that Avaya
™
Vantage waits for DHCPOFFER message
reception on a non-zero VLAN. The range is from 0
to 999.
This parameter is supported in all modes.
For provisioning, use:
• A name=value pair in a DHCPACK message.
• The SET command in the 46xxsettings.txt
file.
• The Settings > Network > Ethernet > VLAN >
VLAN test timer menu on the device.
Controls whether VLAN tags are stripped from
frames forwarded to the secondary Ethernet
interface.
™
Table continues...
134