Avaya Vantage K175 Installing And Administering page 136

Supported configuration parameters
Parameter
DOT1XSTAT
DOT1XEAPS
September 2018
Type Default Is set to
value default
on reset
Numeric 0 Yes
String MD5 Yes
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
Description
Pass through is the forwarding of Extensible
Authentication Protocol over LAN (EAPOL) frames
between the device's Ethernet line interface and its
secondary (PC) Ethernet interface.
The options are:
• 0: EAPOL multicast pass-through is enabled
without proxy logoff.
• 1: EAPOL multicast pass-through is enabled with
proxy logoff.
• 2: EAPOL multicast pass-through is disabled.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file.
• The Settings > Network > Ethernet > IEEE
802.1x authentication > Pass through mode
menu on the device.
Specifies whether the IEEE 802.1X supplicant
operating mode for Ethernet is enabled on Avaya
™
Vantage . The options are:
• 0: Supplicant operation is disabled.
• 1: Supplicant operation is enabled. Avaya
™
Vantage responds only to received unicast
Extensible Authentication Protocol over LAN
(EAPOL) messages.
• 2: Supplicant operation is enabled. Avaya
™
Vantage responds to received unicast and
multicast EAPOL messages.
This parameter is supported in all modes.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file.
• The Settings > Network > Ethernet > IEEE
802.1x authentication > Supplicant mode menu
on the device.
Specifies a list of Extensible Authentication Protocol
(EAP) methods for IEEE 802.1x authentication.
Assign one of the following values:
• TLS
™
Table continues...
136