Avaya Vantage K175 Installing And Administering page 169

Conferencing parameters
Parameter
CONFERENCE_F
ACTORY_URI
Avaya Vantage
Layer 3 QoS parameters
Important:
The following layer 3 QoS parameters are only used in the IP Office environment. In the
®
Avaya Aura
Manager.
Parameter
DSCPAUD
September 2018
Type Default value Is set to
String Null string
™
Basic parameters
environment, the value is taken from PPM and configured through System
Type Default
value
Numeric 46
Installing and Administering Avaya Vantage
Comments on this document? infodev@avaya.com
Description
default on
reset
Specifies the URI that defines the adhoc
conference resource to be used by the
device.
The URI consists of a dial string followed
by @, followed by a domain, which must
match the routing pattern configured in
System Manager for adhoc conferencing.
Depending on the dial plan, the dial string
might need a prefix code, such as 9, to get
an outside line. The domain portion of the
URI can be in the form of an IP address or
an FQDN.
Example:
SET CONFERENCE_FACTORY_URI
"93375000@avaya.com"
With IP Office, this parameter is
automatically generated.
Is set to Description
default
on reset
Yes Specifies the decimal presentation of Differentiated
Services Code Point (DSCP) for audio frames
generated by the device.
You can assign a value between 0 and 63.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file. The precedence is 3.
™
Avaya Vantage Basic parameters
Table continues...
™
169