Siemens SINAMICS G110D Operating Instructions Manual page 59

Setting the AS-i address of slave 2
1.
2.
3.
4.
SINAMICS G110D
Operating Instructions, 07/2016, FW V3.63, A5E36768472B AB
Press the button; the display shows the text SEArcH followed
by uSE 0.
A small 0 is displayed to the left of the display and the number of
the first slave that has already been allocated to slave 1 is shown at
the bottom of the display.
Press the button to select this number.
SEt 0 appears and the small 0 in the left of the display starts flash-
ing.
Press the button until you reach the required number.
By pressing both the
identifiers of the address.
Press the button to accept this number.
ProG is displayed briefly.
Both of the numbers allocated to the slaves are now displayed in
the lower part of the screen.
and simultaneously, you can toggle between A and B
Connection
4.10 Using the AS-i Programmer
59