Configure Process Measurement; Configure Mass Flow Measurement - Emerson Micro Motion 9739 MVD Configuration And Use Manual

Configuration and Use Manual
MMI-20016855

4 Configure process measurement

4.1 Configure mass flow measurement

The mass flow measurement parameters control how mass flow is measured and reported.
4.1.1 Configure Mass Flow Measurement Unit
Display OFF-LINE MAINT → OFF-LINE CONFG → UNITS → MASS
ProLink III Device Tools → Configuration → Process Measurement → Flow
Field Communicator Configure → Manual Setup → Measurements → Flow → Mass Flow Unit
Mass Flow Measurement Unit specifies the unit of measure that will be used for the mass flow rate. The unit
used for mass total and mass inventory is derived from this unit.
Procedure
Set Mass Flow Measurement Unit to the unit you want to use.
The default setting for Mass Flow Measurement Unit is g/sec (grams per second).
Tip
If the measurement unit you want to use is not available, you can define a special measurement unit.
Options for Mass Flow Measurement Unit
The transmitter provides a standard set of measurement units for Mass Flow Measurement Unit, plus one
user-defined special measurement unit. Different communications tools may use different labels for the
units.
Unit description
Grams per second
Grams per minute
Grams per hour
Kilograms per second
Kilograms per minute
Kilograms per hour
Kilograms per day
Metric tons per minute
Metric tons per hour
Metric tons per day
Pounds per second
Pounds per minute
Configuration and Use Manual
Display
G/S
G/MIN
G/H
KG/S
KG/MIN
KG/H
KG/D
T/MIN
T/H
T/D
LB/S
LB/MIN
Configure process measurement
Label
ProLink III Field Communicator
g/sec g/s
g/min g/min
g/hr g/h
kg/sec kg/s
kg/min kg/min
kg/hr kg/h
kg/day kg/d
mTon/min MetTon/min
mTon/hr MetTon/h
mTon/day MetTon/d
lbs/sec lb/s
lbs/min lb/min
June 2019
21