Bowflex Max Trainer M3 Service Manual page 86

Note: Left Shroud is removed for clarity.
30. Note the number of exposed threads below the Tensioner Adjustment Nut.
This will assist with re-assembly.
31. Using a 10mm open face wrench, loosen the Tensioner Adjustment Nut on
the Tensioner Bolt until the Fan Belt can be removed. Remove the Fan Belt
from the Fan Pulley.
Keep fingers out of any pinch opportunities when removing the
Fan Belt.
32. Using a 5mm hex wrench, remove the four screws that attach the Fan Pul-
ley. Be sure to support the weight of the Fan Pulley when removing hardware
because it will fall.
33. Using a 5mm hex wrench, attach the new Fan Pulley to the Frame As-
sembly.
34. Replace the Fan Belt around the new Fan Pulley.
35. Replace and tighten the Tension Adjustment Nut to the same location on
the Tensioner Bolt.
36. Installation is the reverse procedure excluding steps with the Crank Puller.
The Crank Puller is not required for re-assembly.
Note: When replacing the Crank Arms, be sure the Right and Left Crank Arms
are oriented inline and opposite each other.
The Crank Nuts should be tightened to a torque value of 29-32.5 ft lbs (or 350-
390 in lbs).
37. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
Fan Belt
Tensioner
Nut and Bolt
86
Fan
Pulley
Fan Belt
Fan Pulley