7. Place a rag or protective material below the Connector Arm to pro-
tect the Shrouds from potential scratches from the Connector Arms.
Pivot Arm
8. Using a 6mm hex wrench, remove the hardware that connects the
Connector Arms and the Pivot Arms.
Note: The Connector Arm will pivot downward if not lowered slowly
onto the rag protecting the Shrouds.
Connector Arm
9. Using a 9/16" or 14mm socket and wrench, remove the nut from
the Crank Assembly.
10. Adjust the Crank Puller until the end of the Bolt is flush with the
Nut (as shown).
47