Bowflex Max Trainer M3 Service Manual page 110

7. Place a rag or protective material below the Connector Arm to pro-
tect the Shrouds from potential scratches from the Connector Arms.
8. Using a 6mm hex wrench, remove the hardware that connects the
Connector Arms and the Pivot Arms.
Note: The Connector Arm will pivot downward if not lowered slowly
onto the rag protecting the Shrouds.
9. Using an 8mm hex wrench, remove the hardware that secures the
Pivot Arm to the Frame Assembly.
10. Slide the old Pivot Arm off of the Pivot Rod and replace with the
new one.
11. Re-assemble the machine in the reverse order of when the parts
were removed.
12. If necessary, repeat the procedure to replace the other Pivot Arm.
13. Installation is the reverse procedure excluding steps with the
Crank Puller. The Crank Puller is not required for re-assembly.
14. Final Inspection
Inspect your machine to ensure that all hardware is tight and compo-
nents are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
Connector Arm
110
Pivot Arm