Bowflex Max Trainer M3 Service Manual page 48

11. Carefully thread the Crank Puller into the Crank Arm. Be sure the Crank
Puller has at least three rounds of threads inserted.
12. Using a 16mm wrench, turn the inner portion (the Bolt) of the Crank Puller
clockwise. The Crank Arm will slide off as it is tightened.
Note: Be aware that the Crank Arm will be loose and will need to be sup-
ported.
13. Remove the Crank Puller from the Crank Arm.
14. If necessary, repeat the procedure to remove the other Crank Arm.
15. Installation is the reverse procedure excluding steps with the Crank Puller.
The Crank Puller is not required for re-assembly.
Note: When replacing the Crank Arm be sure the Right and Left Crank Arms
are oriented inline and opposite each other.
The Crank Nut should be tightened to a torque value of 29-32.5 ft lbs (or 350-
390 in lbs).
16. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
48