Bowflex Max Trainer M3 Service Manual page 109

Note: The Bowflex Max Trainer
M3 is used in the following images. The
®
procedure is the same for the M5 model.
1. Unplug the AC Adapter from the wall outlet and machine.
1. From the side with the Crank Arm that needs to be replaced, remove
the indicated Cap.
Note: The following photos show the removal of the Left Crank Arm.
Leg Assembly
Foot Pedal
Cap
2. Using a 6mm hex wrench, remove the hardware exposed from below
the Cap.
3. Lift the Foot Pedal and slide the Leg Assembly straight off the ma-
chine. Be sure to pull straight out, or the Leg Assembly may be difficult to
remove.
Note: A rubber mallet may be necessary if the Leg Assembly will not slide
off.
4. Using a 5mm hex wrench, remove the indicated hardware from the
Upper Handlebar.
Note: Be aware that the Upper Handlebar must be supported when
removing the hardware.
5. Using a #2 Phillips screwdriver, remove the 2 indicated screws from the
Crank Cover.
Crank Cover
Note: The image displays the Right Crank Cover being removed.
6. Remove the Crank Cover from the machine.
109