Bowflex Max Trainer M3 Service Manual page 27

Note: The Bowflex Max Trainer
M3 is used in the following images. The
®
procedure is the same for the M5 model.
1. Unplug the AC Adapter from the machine and wait 5 minutes.
2. Using a #2 Phillips screwdriver, remove the indicated (by ovals) screws
and only loosen the lowest indicated screw (arrow) from the Right Fan
Cover.
Note: Loosen the lowest screw by at least 3 full rotations.
3. The Right Fan Cover has a tab that needs to be pushed upward to clear
the loosened screw. While pushing up on the tab, remove the Right Fan
Cover from the assembly.
Note: the AC Power Cable is attached to the inside of the Right Fan
Cover. Be sure not to crimp the cable by placing the Right Fan Cover
close to the front of the machine.
Tab
4. Using a 15mm open face wrench, remove the Securing Ring from the
outside of the Right Fan Cover.
5. Remove the AC Inlet from the inside of the Right Fan Cover.
AC Inlet
Securing Ring
27