Bowflex Max Trainer M3 Service Manual page 116

1. Unplug the AC Power Adapter from the machine and wait 5 minutes.
2. Using two 6mm hex wrenches, remove the Roller Wheel Assembly
from the Pedal Arm.
In order to avoid possible serious injury when removing the
Roller Wheel Assembly, be careful to avoid fingers or hands
being caught or pinched.
Be aware that the Pedal Arms and the Upper Handlebars
are connected and when either of these parts move the
other does as well.
3. Remove and dispose of the old Roller Wheel, Axle, Screws, and any
Washers that were installed.
Note: Some Washers may stick to the Wheel Bracket on the Pedal
Arm. Be sure to remove them before re-assembly.
4. Attach the new Roller Wheel Assembly with the provided hardware.
The new Roller Wheel Assembly includes two Small Metal Washers
and two Large Felt Washers. Make sure the Small Metal Washers are
installed on the outside of the Wheel Brackets, while the Large Felt
Washers are on the inside of the Wheel Bracket next to the Roller
Wheel.
Note: The new washer configuration may differ from what was origi-
nally installed on the machine. The Wheel Bracket is sized so the Axle
can only be inserted in one direction.
Large Felt Washer
5. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
Small Metal Washer
Roller Wheel Assembly
Pedal Arm
116
Small Metal Washer
Large Felt Washer