Bowflex Max Trainer M3 Service Manual page 132

Note: The Bowflex Max Trainer
procedure is the same for the M5 model.
1. Unplug the AC Adapter from the machine and wait 5 minutes.
2. Using a #2 Phillips screwdriver, remove the indicated (by ovals) screws
and only loosen the lowest indicated screw (arrow) from the Right Fan
Cover.
Note: Loosen the lowest screw by at least 3 full rotations.
3. The Right Fan Cover has a tab that needs to be pushed upward to clear
the loosened screw. While pushing up on the tab, remove the Right Fan
Cover from the assembly.
Note: the AC Power Cable is attached to the inside of the
Right Fan Cover. Be sure not to crimp the cable by plac-
ing the Right Fan Cover close to the front of the machine.
Note: Disc Brake is hidden for image clarity.
4. Using a #2 Phillips screwdriver, remove the screw that attaches the
Speed Sensor.
Note: The distance of the new Speed Sensor Magnet must be the same
distance from the Fan Disc for proper operation. Be sure to note the
distance before removing the Speed Sensor Magnet.
M3 is used in the following images. The
®
132
Tab
Speed
Sensor
Fan Disc
Magnet