Bowflex Max Trainer M3 Service Manual page 61

26. Using a #2 Phillips screwdriver, remove the screws from the Left
Shroud. ( 9 screws on the Left Shroud) Remove the upper screws
labeled ' * ' last.
Note: Shrouds are removed for clarity. To assist with re-assembly,
note the orientation of the Drive Pulley before removal.
27. Using a 4mm hex wrench, remove the screw indicated by "A" from the
Drive Belt Tensioner Arm.
28. Using a 8mm hex wrench, loosen the screw indicated by "B" until the
Drive Belt is free enough to be removed from the Drive Pulley. Remove
the Drive Belt.
Keep fingers out of any pinch opportunities when removing
the Fan Belt.
29. Using an appropriately sized hex wrench, remove the four screws that
attach the Drive Pulley. Be sure to support the weight of the Drive Pulley
when removing hardware because it will fall.
* If there is a nut securing the screw on the other side of the Drive Pulley,
loosen it and then remove the screw.
* If the head of a screw a has broken off, grasp the exposed shaft of the
screw with locking pliers and carefully unscrew it.
* If the locking pliers cannot remove the broken screw, use a drill bit and
screw extractor to remove it.
*
Right Side
Drive Belt
Drive Pulley
61
*
Left Side
Drive Pulley
B
A