Bowflex Max Trainer M3 Service Manual page 35

5. Using a #2 Phillips screwdriver, remove the indicated (by ovals)
screws and only loosen the lowest indicated screw (arrow) from the
Right Fan Cover.
6. The Right Fan Cover has a tab that needs to be pushed upward to
clear the loosened screw. While pushing up on the tab, remove the
Right Fan Cover from the assembly.
Note: the AC Power Cable is attached to the inside of the Right Fan
Cover. Be sure not to crimp the cable by placing the Right Fan Cover
close to the front of the machine.
Tab
7. Using a #2 Phillips screwdriver, remove the indicated screw from
the Rear Shroud.
8. Carefully remove the Rear Shroud from the machine. Place a stan-
dard screwdriver behind and near the middle of the Rear Shroud and
gently pry until it releases. Then move the screwdriver to the bottom
and gently pry until the Rear Shroud comes off.
9. Remove the Caps from the machine.
Rear Shroud
Cap
Cap
35