Bowflex Max Trainer M3 Service Manual page 62

30. Using a 5mm hex wrench, attach the new Drive Pulley to the Frame Assem-
bly with the provided screws and lock washers. Fully install each screw.
31. Using a 10mm wrench, secure each of the screws with a provided securing
nut. Be sure all provided hardware is fully tightened.
32. Replace the Drive Belt around the new Drive Pulley. Be sure the Drive Belt
is still in place around the lower pulleys.
33. Replace and tighten the "A" screw on the Drive Belt Tensioner Arm, and then
tighten the "B" screw.
34. Installation is the reverse procedure excluding steps with the Crank Puller.
The Crank Puller is not required for re-assembly.
Note: When replacing the Crank Arm be sure the Right and Left Crank Arms
are oriented inline and opposite each other.
The Crank Nut should be tightened to a torque value of 29-32.5 ft lbs (or 350-
390 in lbs).
35. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are
properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
62