Bowflex Max Trainer M3 Service Manual page 21

Note: The Bowflex Max Trainer
adjustment procedure is the same for the M5 model.
If the Rollers seem to be "off" and not fully tracked on the Rail Assembly,
this procedure may assist.
1. Unplug the AC Adapter from the machine and wait 5 minutes.
2. Using a #2 Phillips screwdriver, remove the 1 indicated screw from the
Rear Shroud.
3. Carefully remove the Rear Shroud from the machine. Place a standard
screwdriver behind and near the middle of the Rear Shroud and gently pry
until it just releases. Then move the screwdriver to the bottom and gently
pry until the Rear Shroud comes off.
4. Remove the Caps from the machine.
M3 is used in the following images. The
®
Rear Shroud
21
Rail Assembly
Roller riding slightly
outward or "off" of
the Rail Assembly
Cap
Cap
Rail Assembly