Bowflex Max Trainer M3 Service Manual page 143

9. Attach a piece of wire or string to the upper Heart Rate Cable of the
Wireless Heart Rate Sensor (where it attached to the Console).
10. Gently remove the Wireless Heart Rate Sensor and Cable, routing the
newly attached wire or string down to the Rear Shroud opening.
Note: If the Wireless Heart Rate Sensor was attached by an adhesive, be
sure to remove any residue to be able to attach the new Sensor correctly.
11. Remove the old Wireless Heart Rate Sensor and Cable, leaving the
piece of wire or string routed through the machine.
12. Attach the Connector end of the new Wireless Heart Rate Sensor to
the wire or string, and gently route the Wireless Heart Rate Sensor cable
up to the Console.
Note: do not crimp the Cable.
13. Remove the routing wire or string from the Wireless Heart Rate Cable.
14. Installation is the reverse procedure.
15. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
143