Bowflex Max Trainer M3 Service Manual page 65

5. Using a 5mm hex wrench, remove the indicated hardware
from the Left Upper Handlebar.
Note: Be aware that the Upper Handlebar must be supported
when removing the hardware.
6. Using a #2 Phillips screwdriver, remove the indicated (by
ovals) screws and only loosen the lowest indicated screw (ar-
row) from the Right Fan Cover.
7. The Right Fan Cover has a tab that needs to be pushed up-
ward to clear the loosened screw. While pushing up on the tab,
remove the Right Fan Cover from the assembly.
Note: the AC Power Cable is attached to the inside of the Right
Fan Cover. Be sure not to crimp the cable by placing the Right
Fan Cover close to the front of the machine.
Tab
65