Available Zone Attributes; Diagnostics - Read Only - DSC iotega WS910 Reference Manual

Wireless security and automation system

Table of Contents

24-Hour

This zone is active and reports alarms at all times when tripped. The siren and keypad buzzer do not activate.

Supervisory

24-Hour

This zone type is used with temperature sensors and is activated when the temperature rises above a programmed threshold. Instant alarm when

Temperature

activated, audible alarm at default. This zone type generates an alarm when the system is armed or disarmed.

Note: The temperature threshold includes a 3 °C (5-6 °F) difference between a given state and its restored condition. For

example, an alarm at 6 °C is restored at 3°C (High temperature) or 9°C (Low temperature), depending upon the zone type selec-

ted.

24-Hour

Instant alarm when activated, audible alarm at default.

Flood

24-Hour Non-

This zone is active at all times but does not cause an alarm. Zone attributes such as Zone Bypassing and Door Chime affect the functionality of this

Alarm

zone. This zone type can also be assigned to a temperature sensor if indoor/outdoor temperature display is required without temperature warnings or

alarm conditions.

Push to Set

Activating this zone starts an infinite exit delay when armed according to the methods described in the table below. To complete the arming

sequence, this zone must be activated and restored. Once done, the exit delay timer starts.

Arming Method

User Code

Keyswitch

Away Key

*0 Arm

*9 Arm

Stay Key

Night Key

Remote Access/SMS

DLS Arm

NAA Arming

Do not use exit delay termination with this zone type. Away arming with this zone bypassed prevents arming.

4.9 Available Zone Attributes

The following table defines each available zone attribute.

Alarm Report When this attribute is enabled, zone alarm and restore events are transmitted. When disabled, zone alarm events are not transmitted but are logged to

the event buffer.

Chime

When this attribute is enabled, the keypad chimes when the zone is opened or closed.

Burglary Veri-

When this attribute is enabled, zone alarms are not communicated until a burglary verified event occurs.

fied

Transmission

When this attribute is enabled, reporting of zone alarms is delayed for the programmed time. If a valid access code is entered within this time, no

Delay

alarm signal is communicated. When disabled, reporting codes are transmitted immediately.

Bell Audible

When this attribute is enabled, an alarm activates the siren. When disabled, alarms are silent.

Bell Steady

When this attribute is enabled, siren output is steady when in alarm. When disabled, siren output pulses during an alarm.

Bypass

When this attribute is enabled, the zone can be manually bypassed. When disabled, the zone cannot be bypassed.

Enable

Force Arm

When this attribute is enabled, the system can be armed with the zone open. The zone is temporarily bypassed and, when secured, is monitored by

the system. Zones with this attribute disabled cannot be armed while the zone is open.

If Open Zone Cancels Arming is enabled, the system can begin arming with an open, Force Arm zone, but if the zone is still open when the exit delay

timer expires, arming is cancelled.

Swinger Shut-

When enabled, a zone that goes into alarm for the number of times programmed in the Swinger Shutdown Counter shuts down with no further trans-

down

missions sent to the monitoring station. The siren follows swinger shutdown if programmed. When disabled, all alarms are transmitted.

Two Way

When this attribute is enabled, the panel is able to initiate a 2-way audio session. When not enabled, only the panel microphone turns on, initiating a

Audio

listen-in only session. The speaker remains off.

Talk Listen

The central station operator and the end user can communicate through the panel's microphone and speaker.