Table of Contents
Advertisement
LED
Indicator
Power
ON Steady
[Green]
OFF
Flashing
Ready
ON Steady
[Green]
OFF
Flashing [Green]
Armed
ON Steady
[Red]
Flashing
[Red]
Flashing
[Red]
OFF
Trouble
ON Steady
[Amber]
Single flash
[Amber]
Two flashes
[Amber]
Three Flashes
[Amber]
Flashing
[Amber]
OFF
Wi-Fi Signal
ON Steady [Green] Strong Signal Connection
ON Flashing
Strength
[Green]
ON Steady
[Amber]
ON Flashing
[Amber]
On Steady [Red]
Flashing
[Amber]
OFF
Section 2: Installation
Description
AC power is connected to the system
· System is not powered On
· NO AC connected, and system is operating on backup battery
· NO AC connected and backup battery is discharged
System test in progress ( Ready, Trouble and Arm LED's flashing at same time)
Partition is ready to arm
Partition is not ready to arm. Not all zones are secure or an alarm is present.
Installer Walk Test ( Ready, Trouble and Arm LED's flashing at same time) or sys-
tem test in progress ( Ready, Trouble and Arm LED's flashing at same time)
Partition is armed
System in Alarm. [Note: this LED does not flash for silent alarms or panic alarms]
Installer Walk Test ( Ready, Trouble and Arm LED's flashing at same time) or sys-
tem test in progress ( Ready, Trouble and Arm LED's flashing at same time)
Partition is disarmed or audible alarm annunciation is deactivated
System trouble is present
[*][2] System Trouble menu level 1
[*][2] System Trouble menu 2
[*][2] System Trouble menu 3
Access code is required to view Trouble menu, Installer Walk Test ( Ready,
Trouble and Arm LED's flashing at same time) or a system test is in progress (
Ready, Trouble and Arm LED's flashing at same time)
No system troubles
Wi-Fi active in WSA mode (for AP mode)
Radio active with weak signal connection
Z-Wave is active in learn pair mode
No Signal
System Test ( AC, Ready, Trouble, Arm LED's, WiFi Trouble, Cellular Trouble &
System Remote Status flashing at same time)
WiFi disabled
- 10 -
Advertisement
Table of Contents
